Mounting Of The Warning Device - Pepperl+Fuchs LAL-SRW-08 Manual

ALARM SYSTEM
Installation
3.2

Mounting of the warning device

Note!
If the device is installed in a housing or switch cabinet, note the mounting instructions of the
housing or switch cabinet manufacturer.
Caution!
Overheating
If outside temperature exceeds 60 °C with maximum load, this may result in damage to the
device.
• Ensure there is sufficient ventilation at the place of installation.
• Observe a minimum clearance of 5 mm between devices on the DIN rail.
Installing the warning device on the DIN rail
Snap the device onto the DIN rail as follows:
Click!
EN
EN - 17