Charging The Battery Pack - Kenwood ProTalk DIGITAL TK-3701D User Manual

CHARGING THE BATTERY PACK

ATTENTION:
◆ Always switch OFF a transceiver equipped with a battery pack before inserting the
transceiver into the charger.
Plug the AC adapter cable into the jack located on the rear of the charger.
1
Plug the AC adapter into an AC outlet.
2
Slide a battery pack or a transceiver equipped with a battery pack into the
3
charging slot of the charger.
• Make sure the metal contacts of the battery pack mate securely with the
charger terminals.
• The indicator lights red and charging begins.
When charging is completed, the indicator flashing green. Remove the battery
4
pack or the transceiver from the charging slot of the charger.
• It takes approximately 3 hours to charge the battery pack.
• When the charger will not be used for a long time, unplug the AC adapter
from the AC outlet.
Note:
◆ When the indicator blinks red, the battery pack is either defective or the battery pack
contacts are not properly mated with those of the charger.
◆ When the indicator flashes green and orange, the battery pack has not satisfied the
charging start temperature. Remove the battery pack from the charger and wait until it
reaches a normal temperature before charging it again.
◆ The ambient temperature should be between 5°C and 40°C while charging is in
progress. Charging outside this range may not fully charge the battery.
◆ The battery pack life is over when its operating time decreases even though it is fully
and correctly charged. Replace the battery pack.
Indicator
4