Curtis FreshTrac TFT Series User Manual page 7

PROGRAMMING GUIDE
Programming the Display
The following parameters can be programed:
• Fresh Coffee (FreshTrac) Timer (FSH) - Sets the amount of time from the start of the brew cycle to expiration
• Count Up/Down (Cnt) - Sets the FreshTrac timer to count up or count down (default is count down).
• Display Options (dSP)
• LED Green Light ON/OFF (FSI) - Disables the green LED only (default is on).
• Factory Reset (rST)
Entering Programming Mode
from the top.
2
programming marks (
stem protruding from the bottom. Touch and hold
(DO NOT PRESS) the up ( ) and down ( ) arrows
until 2 horizontal lines appear on the display.
display.
Touch and release down ( ) repeatedly until the parameter you wish
5
touch on the stem to program the displayed parameter*:
• FSH - FreshTrac Timer - When you press
Touch and release up ( ) and down ( ) to change the setting. Press
Cnt - Count Up / Count Down - When you press
Means count down.
Touch and release up ( ) to change to count up and down ( ) to change to count down. Press
and exit.**
) on the long plastic
FSH will appear on the
Means count up.
continued...
PG26
Programming
marks