Remote Diagram - Krell Industries Vanguard Series Owner's Reference Manual

Vanguard Integrated Amplifier /
Remote Control Buttons have the same function as the
front panel controls, when applicable.
u
Power
Use this button to switch the
Vanguard between stand-by and operational modes.
v
Mute Button
Use this to mute the Vanguard output. To un-mute,
press the mute button again.
w
Analog Input Buttons (VIA and DVI)
Use these buttons to select analog inputs on the
Vanguard.
x
Digital Input Buttons (DVI, DAC)
Use these buttons to select digital inputs on the
Vanguard. Note: These buttons are only active when
the optional digital module is installed.
y
BAL (Balance) Buttons (VIA,DVI)
Use these buttons to shift the balance to the left or the
right channel. Note: In menu mode, the balance but -
tons are used for left and right navigation.
z
The Enter button
Use the enter button to confirm menu selections.
{
Volume Up/Down Buttons
Adjusts volume up and down on VIA, DVI and
DAC with a range of 0-100.
|
Menu Button
Use this to access the menu functions of the Vanguard
}
CD / DVD Transport Control
Not in use for Vanguard; used to control basic
CD / DVD functions on other Krell products.
www.krellonline.com
Digital Vanguard Integrated Amplifier
Vanguard Universal DAC
Vanguard Family - Owner's Reference
7
Figure 3 - Remote Control
u
w
y
{
Note: The remote comes with two AAA batteries
that have to be installed. Use the supplied Torx
Screwdriver to remove the 4 battery panel Torx
screws (T10) then install the batteries.
© 2015 by Krell Industries, LLC
v
x
z
|
}
All rights reserved