Krell Industries Vanguard Series Owner's Reference Manual page 4

Open the shipping box and remove the top layer of
foam. You will see these items:
1. Vanguard unit and Accessories - Included
A. 1 AC power cord
B. 1 handheld remote control
C. 2 AAA batteries
D. 1 CD w/ owner's reference
E. 1 warranty registration card
F. 1 trigger cable
G. 1 T-10 Torx Screwdriver
2. Carefully remove all items from the shipping box.
3. Place the preamplifier and power supply in a safe
location and remove the protective plastic wrapping.
Place the Vanguard on a firm, level surface, away
from excessive heat, humidity, or moisture. The
Vanguard is a precision instrument and should be
handled with the utmost care when deciding where
it is to be placed and while it is being unpacked and
finally installed. Make sure the installation location
is dry and level, and able to provide adequate ven-
tilation. The Vanguard runs warm to the touch and
requires the bottom and top of the unit be free from
obstruction with good circulation of air. Allow a
minimum of 2 inches (5cm) above the unit for proper
ventilation, and at least one inch (2.54 cm) on each
side. Additional ventilation may be required when
the unit occupies the same space with other electron-
ics that generate heat, like power amplifiers. Please
consult an authorized KRELL dealer or KRELL
Industries to insure proper installation guidelines.
www.krellonline.com
Unpacking / Placement / AC Power Guidlines
Vanguard Family - Owner's Reference
The Vanguard is designed to work all over the world.
The operating voltage is determined at the factory and
is specifically set to operate in the country of final
destination. The Vanguard requires good clean power
and doesn't require additional filtration. A 15 Amp
circuit is recommended for the Vanguard.
Note:
The Vanguard may not operate correctly when AC
regeneration or voltage conversion devices are
utilized, but at a minimum, they must be rated for the
maximum power consumption of the Vanguard.
Note:
Save all packing materials; if you need to ship the
Vanguard in the future, repack the unit in its original
packaging to prevent shipping damage.
Recommended Cleaning Instructions for Krell Products
Clean your Krell product gently, using a high quality
lint-free cloth that has not been treated with chemicals
of any kind.
Please note the following: Do not use cleaning agents
of any kind, such as water, alcohol, or other common
cleaning products.
Thank you.
© 2015 by Krell Industries, LLC
4
All rights reserved