Krell Industries Vanguard Series Owner's Reference Manual page 10

Vanguard Integrated Amplifier/Digital Vanguard Integrated Amplifier - Operating the Vanguard
Operating the Vanguard When powering up any sys-
tem, always turn amplifiers on last. When powering
down, always turn amplifiers off first.
1. When the amplifier is in stand-by mode - with the
red stand-by indicator (2) - turn the amplifier on by
pressing the power button on the front panel or the
power key on the remote control (1). There are audi-
ble clicks and the blue power indicator (2) will illumi-
nate. The Vanguard is now in the operational mode.
2. With the amplifier in the mute position, or the vol-
ume control fully attenuated (O), select a source (4)
from the front panel or the remote control.
{
u w
Menu Options
(from Remote or Front Panel)
The Vanguard menu system offers a number of
options and information. Main selections include:
• Source Setup
• Network Setup
• Operation Mode
• Diagnostic Mode
• Software Version
• Software Update
• Display Setup
• Restore Settings
• Save Settings
• Serial Number
Press the Vanguard's Menu button (7), then use the
navigation buttons or keys to highlight one of the
menu options. Press the Enter button or key to select.
www.krellonline.com
Vanguard Family - Owner's Reference
x
3. Start playing the source.
4. Set the volume to a comfortable listening level
using the up or down keys on the front panel or the
level keys on the remote control (3).
5. To turn the amplifier off, press the power button on
the front panel or the power key on the remote control
(1). The red stand-by indicator (2) illuminates. It is
now safe to turn off the rest of the system.
v
Source Setup
Press the Enter button and use the Up or Down but-
tons to highlight the desired parameter to edit. Press
the Enter button to select. Assign Names: The first
input is displayed. Press the Up or Down buttons to
select a different source.
To edit the currently displayed source, press the Enter
button and the cursor will begin flashing at the first
character field. Use the Up or Down buttons to change
the character. Use the Right or Left buttons to move
the blinking cursor to another character and repeat the
editing procedure. Press Enter to confirm changes.
Press the Up or Down buttons to select a different
source and repeat the editing process. The edited
name will appear when the Source button is pressed
on the remote or front panel. The new source name
© 2015 by Krell Industries, LLC
10
All rights reserved