Table of Contents
Advertisement
Vanguard Integrated Amplifier/Digital Vanguard Integrated Amplifier - Operating the Vanguard
The Vanguard processor operation and setup options
are available from the built in web server. To use the
web server, connect the Vanguard to a router in your
local network (LAN). The IP address can be found in
the Network Setup sub menu. Press the Enter button
twice to find the address of the unit. It should be
similar to 192.168.1.9.
To access the web server, type your IP address
into the web browser address bar; press Enter.
For above, the correct address to enter would be:
192.168.1.9. The Vanguard control web page will
now appear on your computer or tablet screen. Using
your mouse or finger, follow the remote control or
front panel instructions to operate the Vanguard.
Diagnostic Mode
Diagnostic mode is used for troubleshooting and is
disabled as a default. Leave diagnostic mode disabled
unless directed by Krell.
Software Version
Press the Enter button to view current operating
Vanguard Software version and build date
Software Update
Press the Enter button to display the Software Update
Press the Enter button to select and then the Enter
button again to confirm. Choose the Network option if
the Vanguard is connected to the internet. The Van-
guard will check the Krell update server to determine
if a new software update is available.
Display Setup
Backlight time-out
Backlight time-out turns off the front panel display
after a period of inactivity. The default time setting is
not disabled which keeps the display always illumi-
nated. Time out can be set between 15 and 129
seconds, in 15 second increments.
www.krellonline.com
Vanguard Family - Owner's Reference
12
Contrast Setup
Three contrast levels are available with level 2 being
the default. Press the Enter button to activate the
level setting and then use the up or down button to
adjust. Press the Enter button to confirm the desired
choice.
Restore Settings
Restore Settings will return the Vanguard to the origi-
nal factory settings or to previously saved user
settings. Press the Up or Down button to change to
User. Press the Enter button to confirm selection.
Press the Enter button again to return to factory
or user saved settings. The Vanguard will display
various messages and will eventually return to the
standby mode.
Save Settings
Save Settings will save all configuration settings in
non volatile memory. Press the Enter button to begin
saving process.
Serial Number
Serial number displays the unit's serial number and is
not user editable.
CEC Operation (Only applies to digital board option)
Consumer Electronics Control (CEC) is an HDMI
feature designed to allow the user to control up-to
15 CEC-enabled devices, that are connected through
HDMI, by using only one of their remote controls
(for example by controlling a television set, set-top
box, and DVD player using only the remote control
of the TV). The default setting for CEC is Enabled. In
some installations, it desirable to have CEC operation
disabled. To disable CEC operation, Press the Enter
button and use the Up or Down button to change the
setting ( Blinking E ) to Disabled. Press the Enter
button to confirm change.
© 2015 by Krell Industries, LLC
All rights reserved
Hide quick links:
Advertisement
Table of Contents
