EINHELL RT-PG 2500 Operating Instructions Manual page 15

Anleitung_RT_PG_2500_SPK1:_
GB
9. Troubleshooting
Fault
Engine does not start
Generator has too little or no
voltage
14
10.01.2008 14:31 Uhr Seite 14
Cause
Automatic oil cut-out has not
responded
Spark plug fouled
No fuel
Controller or capacitor defective
Overcurrent circuit-breaker has
triggered
Air filter dirty
Remedy
Check oil level, top up engine oil
Clean or replace spark plug
(electrode spacing 0.6 mm)
Refuel / have the petrol cock
checked
Contact your dealer
Actuate the circuit-breaker and
reduce the consumers
Clean or replace the filter