Universal Boot Installation - Peco X20 Convertible Trailer Vac Operator's Manual

Universal Boot Installation

Remove the discharge chute from the mowing deck as
shown in Figure A.
Figure A
Figure 2-16a
Position the plastic boot over the opening on the mower
deck and trace the opening outline onto the plastic boot.
Refer to Figure B.
Figure B
CAUTION
!
NOTE: To prevent injury, wear the appropriate personal
protection equipment when drilling or cutting plastic boot.
Place plastic boot on a secure surface and carefully drill
a hole into the plastic boot in preparation for the cutout.
Use a 3/8" or 1/2" drill bit. Refer to Figure C for hole
location.
18
Remove
Discharge
Chute
Trace Outline Of
Deck Opening
Onto The Plastic Boot
Figure C
Drill Here
Using a jigsaw, cut along the traced outline and the
bottom edge of the plastic boot. Discard the cutout
portion of the boot. Refer to Figure D.
Figure D
Place the plastic boot against the deck opening again
and check for blade clearance. Trace the outline of the
blade extent (with clearance) onto the bottom edge of
the boot. Refer to Figure E.
Figure E
Deck Opening
Outline
Cut Along The
Traced Outline
Cut Along
Bottom Edge
Check For
Blade Clearance