Engine/Blower/Blade Assembly
Installation
Remove the engine/blower/blade assembly from the
box. Place the engine on top of the engine mount arm as
shown in Figure A.
Figure A
Housing Opening
Should Face Mower
Deck Discharge
Secure the engine/blower/blade assembly to the engine
mount arm with (4) 5/16"-18 x 1-1/2" hex bolts
P#(K1157) and (4) 5/16"-18 locknuts P#(K2516). Refer
to Figure B.
Figure B
Inlet Ring Installation
Pull the Locking Pin P#(K0095) up from the Inlet Ring P#(V1052). Position the 6" Inlet P#(E8010) into the Inlet Ring
and secure the 6" Inlet by pressing the Locking Pin back down. Refer to Figure A.
Figure A
Inlet Ring
Engine/Blower
Blade Assembly
Engine
Mount Arm
(4) 5/16"-18 x 1-1/2"
Hex Bolts &
(4) 5/16"-18 Locknuts
Locking Pin
Blower Cone Installation
Loosen the blower cone hardware just enough so that
you can remove the plastic cover from the blower
housing shown in Figure A.
Figure A
Plastic Cover
Insert the blower cone as shown in Figure B and secure
with the existing blower cone hardware.
Figure B
6" Inlet
Blower Cone
Hardware
Blower Cone
Hardware
Blower
Cone
11