auna 10032013 Manual page 40

EN
40
Alarm
To set up three alarms (Alarm 1, Alarm 2, NAP Alarm) and the Alarm Volume.
1 Press Power Configuration. Press OK to confirm.
2 Press Rotate Navigate button to choose "Alarm".
3 Press OK button to enter the interface.
Settings:
• When alarm rings, it will enter the display of "Standby" automatically.
• You can set up the alarm volume by "Alarm Volume".(Volume 7 is
default)
• If you press any button when alarm rings,the alarm will be closed and
enter the model of standby with 5 minute SNOOZE.
• To press Standby button, it will exit the mode of SNOOZE.
• After the alarm setup, you should exit it, then the new setup can come
into use.
• Two alarms won't ring at the same time.(Only after one alarm stop
ringing, another alarm can be used).
NAP Alarm
The time of NAP Alarm is from 5 minutes to 120 minutes.And after the setup
of the NAP Alarm, it begins to count down the time until the time is over,
then it will switch to the standby model automatically and rings.