Mains Connection; Dust Connection - Jet JRT-2 Operating Instructions Manual

Attach the Fence Boards and Dust Port (Fig 10):
Attach the fence boards to the fence, with 4 carriage bolts,
washers and knobs. Attach the dust port (D).
Attach the Workpiece Hold Down ´s:
Attach the hold down support (N, Fig 11‐1) with two screws
and nuts (P).
Attach the workpiece hold down (D) with two carriage bolts,
washers and knobs (O).
Attach the feather boards (Fig 11‐2, Fig 11‐3)
Fig 10
Fig 11‐1
Fig 11‐2
Attach the Table Inserts:
Always use the smallest table insert possible (Fig 11‐4).
Assemble the Mitre Gauge (Fig 12):
5.3 Dust connection
Before initial operation, the machine must be connected to a
dust extractor. The suction should switch on automatically
when the router is switched on.
5.4 Mains connection
8
Fig 11‐3
Fig 11‐4
Fig 12