Instructions For Use - Taiji TSK-110A Operating Instructions Manual

Instructions for Use

1.
Push the power cord plug into a wall outlet.
2.
Press the power switch.
When the "power switch" is pressed, the "power
lamp" is lit and the electric power begins to be fed.
At the same time, the "water supply lamp" is lit and
an alarm keeps sounding to indicate the "need for
water supply."
3.
Feed water or hot water to the water bath tank.
Use a funnel and feed water or hot water through
the water feeding port, to the level of "proper" at
the water level meter. (Fig. 7)
• The "proper" level corresponds to about 4.7
liters. (About 6.7 liters for the TSK-220A, TSK-
230A, and TSK-420A)
* When water is fed to the "lowest" level of the
water level meter, the "water supply lamp" and
the "alarm" go out. However, you should keep
feeding water to the "proper" level.
• In case of overfeeding, water will come out of
the exhaust port. In such a case, open the
water drain valve and discharge water to the
"proper" level.
• If water is too less, sake warming performance
will be lowered.
Caution
• Never feed any liquid other than water or hot
water.
4.
Adjust the sake warming temperature.
1) When the "temperature setting switch" is
pressed once, the temperature setting mode is
assumed.
Initial setting is at [OFF].
• The setting indication and the sake warming
temperature are as specified below. However,
they can change under various conditions, and
they should be used as a guideline.
Lukewarm
Hot
2) Each time the "temperature setting switch" is
pressed once, the temperature indicator lamp
moves up from one after another along the
diagonal line. (Fig. 8)
Approx. 45°C
Approx. 65°C
(Lukewarm)
(OFF)
-7-
<Fig. 7>
(Hot)
(Temperature
setting)
<Fig. 8>