Table of Contents
Advertisement
2.
With the rod mounting screws loosened, slide the monitor rods
through the rod mountings in the base of the prompter monitor.
3.
Refit the end caps to the end of the monitor rods.
4.
With the monitor supported, carefully slide the end clamps of the
prompter monitor rods into the slot on the front of the extrusion.
5.
Ensure that the indents on the end clamps are correctly seated on
the extrusion.
Installation
13
Advertisement
Table of Contents
Need help?
Do you have a question about the E.P.I.C. 17 Inch TFT and is the answer not in the manual?
Questions and answers