Device Maintenance; Maintenance; Water Filter Replacement Or Maintenance - Satelec SUPRASSON P5 NEWTRON User Manual

6. 3 SUPRASSON P5

MAINTENANCE

a) Maintenance
The S P5 N
®
UPRASSON EWTRON
the handpiece cord, should be cleaned and
disinfected (using alcohol and/or disinfectant
dental wipes) on a daily basis.
b) Inspection
The accessories and cords should be inspected
regularly for insulation faults and replaced if
necessary.
It is important to check the state of cleanliness of
the air vents of the control unit in order to avoid
overheating.
Check there is no trace of damp in the handpiece
connection, otherwise dry it (wipe it and blow on
it with the multifunction syringe).
WARNING: Do not use the device if it appears to
be defective.
Note : If a fault occurs, it is advisable to contact
the supplier of your S
UPRASSON
than have it repaired by an unauthorized person.
VII - MAINTENANCE
NEWTRON DEVICE
®
control unit, as well as
Note: for carrying out repairs to defective items
where such repairs can be carried out, SATELEC
makes all information necessary available to
technical staff of the SATELEC® approved dealers
network on request.
7. 1 WATER
The water filter should be cleaned regularly and
should be changed every 6 months.
This is done in the following manner (Figure 4):
- Switch off the water supply, switch off the
- Unscrew the two parts of the filter (Figure 4,
- Withdraw the filter cartridge (Figure 4, diag. 3)
P5 N rather
®
EWTRON
- Proceed in the same manner for the seal.
- Carry out the procedure in reverse to
- Check that the spray operates correctly and
Warning: a worn or damaged cartridge should
be replaced.
FILTER REPLACEMENT
MAINTENANCE
device (OI position) then unplug the mains plug
(Figure 4, diag. 1).
diag. 2) using two 10mm open-ended
wrenches.
to replace (ref: F 10389) or clean it under
running water.
reassemble (Figure 4, diags. 4,5 & 6).
that there are no leaks (Figure 4, diag. 7).
®
OR
13