Troubleshooting - Philips AJ260/05 User Manual

Philips weather clock radio aj260
Hide thumbs Also See for AJ260/05:
Table of Contents

Advertisement

Troubleshooting

If a fault occurs, first check the points listed below before taking the set for repair.
If you are unable to remedy a problem by following these hints, consult your dealer or
service center.
WARNING:
stances should you try to repair the set yourself, as this will invalidate the warranty.
No sound.
– Volume not adjusted.
• Adjust the VOLUME.
Display error / no reaction to any
controls.
– Electrical malfunction
• Press RESET hole on the bottom of the set with
a ball pen.
Occasional crackling sound during FM
broadcast.
– Weak signal.
• Extend the pigtail antenna fully.
The alarm does not function.
– Alarm time not set.
• See section on Setting alarm time.
– Alarm mode not selected.
• See section on Setting alarm mode.
– Volume too low for radio.
• Increase the volume.
CAUTION
High voltage! Do not open.You run the risk of getting an electric shock.The
machine does not contain any user-serviceable parts.
Modification of the product could result in hazardous radiation of EMC or
other unsafe operation.
Do not open the set as there is a risk of electric shock. Under no circum-
The time searched by RCC is not my
local time
– When the set is reset or power is disconnet-
ed/disrupted, RCC time is Central European
time.
• Adjust the time to your local time. See
"Manual setting"
Note:
After the time is adjusted to your local time, RCC
will regularly auto update to your local time
The main unit cannot read or update out-
door temperatuare from the sensor
– No signal or weak signal.
• Reset both the main unit and the sensor. Or
improve the sensor reception. See " Using the
sensor to detect outdoor temperature".

Hide quick links:

Advertisement

Table of Contents
loading

Subscribe to Our Youtube Channel

This manual is also suitable for:

Aj260

Table of Contents