Table of Contents
Advertisement
• For the 86100A, refer to
• For the 86100B, refer to
• For the 86100C, refer to
Servicing requires
special tools
• T-6 screwdriver p/n 8710-1618
• T-8 screwdriver p/n 8710-1614
• T-10 screwdriver p/n 8710-1623
• T-25 screwdriver p/n 8710-1617
• T-15 screwdriver p/n 8710-1622
• wire cutter p/n 8710-0012
• small pozidrive screwdriver p/n 8710-0899
• long-nose pliers p/n 8710-1107
• Flexure Lock p/n 5022-0115
• 4-mm allen driver
• 5/64 allen driver
General Information
Introduction
Introduction
In this chapter, you will find general information on caring for your optical devices. This manual
documents the service and repair of the Agilent 86100A/B/C to the assembly level. Before ser-
vicing the mainframe, you should be aware that amplitude calibration data can only be installed
by the factory. Whenever you contact Agilent Technologies about your mainframe, have the
complete serial number and option designation available. This will ensure you obtain accurate
service information. Refer to
assembly, refer to the following figures:
Figure 8-1 on page 8-5
Figure 9-1 on page 9-5
Figure 10-1 on page 10-6
Protect against ESD damage
Electrostatic discharge (ESD) can damage or destroy electronic components. All work on elec-
tronic assemblies should be performed at a static-safe work station.
charge Information" on page 1-8
Table 1-1. Internal Labels
The tools listed below are required to repair all versions of the Agilent 86100A/B/C.
1-2
Table 1-1
for a list of internal labels. To locate a major instrument
for more information on preventing ESD.
This label warns you about hazardous voltages
present on the power supply. Use extreme caution.
Refer to "Electrostatic Dis-
Advertisement
Chapters
Table of Contents
