Agilent Technologies Infinium DCA 86100A Service Manual page 140

Replacing Instrument Assemblies
To Remove the Front Panel
Figure 7-9. Removing Screws that Secure the Cal Connector
6 Disconnect the W5 and W6 ribbon cables, shown in
Figure 7-10. Removing the W5 and W6 Ribbon Cables
7 Disconnect the W3 mylar flex cable, shown in
end of the connector, using a small flat-blade screwdriver. Do not force the retainer; it should
remain attached to the body of the socket.
7-8
Figure 7-10.
W5
W6
Figure 7-11. Pry up the retainer slightly at either