Operation; Planing Chamfers - Westfalia DB-82X2 Instruction Manual

Operation

Make sure that the power mains voltage in your area corresponds to the
operating voltage stated on the type label.
If possible, connect the machine to a vacuum cleaner or a dust extractor.
Make sure the machine is turned off before connecting it to the power mains.
Use the turn knob to set the cutting depth of the planer. Turning the knob will
raise or lower the forward sole of the planer.
Turning the knob clockwise increases the cutting depth.
Turning the knob counter clockwise decreases the cutting depth.
Insert the power plug into a suitable wall socket. For safety reasons the
machine is equipped with a pressure switch with a safety against accidental
activation. The switch can not be locked in the ON position.
To turn the unit off, simply let got the main switch, it is locked in the OFF
position by the safety device. Before each pass place the forward sole of the
planer on the work piece. The knives must be clear of the work piece at this
point. Make sure the forward sole is flat on the surface of the work piece.
To turn on the machine, press the locking button and then the main switch.
The machine now runs with constant speed. Before starting work, allow the
machine to reach full working speed.
Guide the machine over the surface of the work piece slowly with even speed.
Take care to work in the direction of the wood fibres; the wood may be ripped
when working across the fibres. When starting a pass press the forward sole
on the surface, when you have proceeded far enough, press the rear sole
down. Always make sure the machine moves parallel to the surface of the
work piece. Do not move the machine too fast to avoid jamming it with wood
chips.
Be sure to keep the power cable away from the spinning blades!
Do not set the machine down before the knife cylinder has stopped. Place the
machine on the side to avoid damaging the knives.

Planing Chamfers

There is a groove in the centre of the forward sole. To plane a chamfer, place
the machine on the edge of the work piece with the groove. Now plane the
chamfer in the desired angle. For the best result, move the machine only very
slowly.
Operation
7