Error Messages; Troubleshooting - Panasonic KX-TGF310CX Operating Instructions Manual

Useful Information

Error messages

Display message
Base no power
or
No link.
Reconnect
AC adaptor.
Check
Phone Line
Error
Memory Full
Use
rechargeable
battery.
You must first
subscribe
to Caller ID.

Troubleshooting

If you still have difficulties after following the instructions in this section, disconnect the base unit's AC
adaptor, then reconnect the base unit's AC adaptor. Remove the batteries from the handset, and then
insert them into the handset again.
If the base unit batteries for power backup are installed, remove the batteries from the base unit, and
then insert them into the base unit again.
General use
Problem
The handset does not turn on
even after installing charged
batteries.
The unit does not work.
The handset display is blank.
50
KX-TGF310_320CX(en)_0429_OI.pdf 50
Cause/solution
R Confirm the base unit's AC adaptor is connected to the unit and
the power outlet correctly.
R The handset has lost communication with the base unit. Move
closer to the base unit and try again.
R Unplug the base unit's AC adaptor to reset the unit. Reconnect
the adaptor and try again.
R The handset's registration may have been cancelled. Re-register
the handset (page 53).
R The supplied telephone line cord has not been connected yet or
not connected properly. Check the connections (page 8).
R Recording was too short. Try again.
R The phonebook memory is full. Erase unwanted entries (page 24).
R The call block list memory is full. Erase unwanted entries
(page 22).
R A wrong type of battery such as alkaline or manganese was
inserted. Use only the rechargeable Ni-MH batteries noted on
page 4, 6.
R You must subscribe to a Caller ID service. Once you receive
caller information after subscribing to a Caller ID service, this
message will not be displayed.
Cause/solution
R Place the handset on the charger to turn on the handset.
R Make sure the batteries are installed correctly (page 8).
R Fully charge the batteries (page 9).
R Check the connections (page 8).
R Unplug the base unit's AC adaptor and remove the batteries from
the handset to reset the unit. Reconnect the adaptor, insert the
batteries into the handset and try again.
R The handset has not been registered to the base unit. Register
the handset (page 53).
R The handset is not turned on. Turn the power on (page 14).
4/29/2015 4:08:41 PM