Panasonic KX-TGF310CX Operating Instructions Manual page 37

R When enhanced security is enabled, sound may
cut in and out during conversations.
Changing the base unit PIN
Important:
R If you change the PIN (Personal Identification
Number), please make note of your new PIN.
The unit will not reveal the PIN to you. If you
forget your PIN, contact an authorised service
centre.
Handset / Base unit
1
M N#132
2
Enter the current 4-digit base unit PIN (default:
"0000").
3
Enter the new 4-digit base unit PIN. a MOKN
4
MbN: "Yes" a MOKN
5
Proceed with the operation for your unit.
Handset: M N
Base unit: M N
Increasing the range of the base unit
You can increase the signal range of the base unit
by using a DECT repeater. Please use only the
Panasonic DECT repeater noted on page 4.
Contact your Panasonic dealer for details.
Important:
R Before registering the repeater to this base unit,
you must turn the repeater mode on.
R Do not use more than one repeater at a time.
Setting the repeater mode
Handset / Base unit
1
M N#138
2
MbN: Select the desired setting. a MOKN
3
Proceed with the operation for your unit.
Handset: M N
Base unit: M N
Registering the DECT repeater (KX-A405/
KX-A406) to the base unit
Note:
R Please use a repeater that has not yet been
registered to another unit. If the repeater is
registered to another unit, deregister it first,
KX-TGF310_320CX(en)_0429_OI.pdf 37
referring to the Installation Guide for the DECT
repeater.
1
Base unit:
Press and hold M N for about 5 seconds.
2
DECT repeater:
Connect the AC adaptor, then wait until the
indicator and indicator light green.
3
Base unit:
To exit the registration mode, press M
Programming
N.
37
4/29/2015 4:08:40 PM