WMF 1400 Installation Instructions

Installation Instructions

For initial startup on delivery ex works.
Please refer to WMF 1400 User Manual. Pay special attention to the hazard notices and
Safety chapter.

Unpacking

Unpack the WMF 1400 and place it on a firm horizontal surface.

Mains Connection

Connect mains cable to a fused three-pin power point.
Mains Required:
(Kindly note the required Mains Power and Voltage as shown on the type label of the machine)
Standard: 220 V - 230 V/50 Hz, (2000-2200 W) fuse 10 A minimum!
Japan: 200 V/50/60 Hz, (2000 W) fuse 15 A minimum!
USA: 120 V/50 Hz, (1700 W) fuse 15 A minimum!

Switch On

Press and hold ON/OFF button
™
WMF 1400 switches on and startup program commences.
The WMF 1400 takes you using step by step dialogues through the installation routine.
Perform each step only when instructed on the display!

Water Tank

™ Remove water tank [1], remove lid
Take out accessory components contained
™
Water tank option only!
Rinse out water tank and fill with clean cold mains water
™
Place lid on water tank and replace until it meets the stop
™

Water filter (optional)

Remove the integrated water spout strainer from the water tank
™
Insert the cartridge adapter into the water spout supports from above (with lock open) and lock
™
into place [2b]
Unpack the water filter cartridge and insert into the cartridge adapter
™

Coffee Grounds Container

Push combi spout fully upwards
™
Push up adjustable screen
™
Remove coffee grounds container
™
Replace coffee grounds container until it meets the stop
™
Close adjustable screen
™

Constant Water Supply (optional)

Carefully insert seals attached to connecting tube
™
Using hose connect union on rear of machine
™
as appropriate
If using WMF AquaQuell 1.5 Filter System follow its User Manual.
Turn on water
™
Check unions for leaks and tighten if necessary!
™

Drain Outlet (optional)

Push drain tube with angle onto water drain connector on rear of machine
™
Connect drain tube to mains drain via an S-trap
™
Tube must not sag. Shorten tube if necessary!
™
for 2 sec min.
[3a] over coffee grounds container
[3b] and remove accessories
[4a] to existing water tap
[2a]
[2c]
[4b] or anti-scale filter
[5]
Packaging material in box contains accessories! Do
not throw away!
For accessories and identifiaction of machine
components see User Manual!
Make sure that the coffee machine is in perfect
condition. In the event of doubt do not start up
and inform WMF Service.
Keep original packaging in the event of any
subsequent return!
For installation terms and conditions see
User Manual!
Do not loosen any screws and do not remove any
housing parts - there is danger to life inside the
machine due to mains voltage!
1
2b
3a
4a
Siphon = S-bend (odour trap) (as on dishwahers)
33 2329 5000 1.10 05.2008
2a
2c
3b
4b
5