Ethernet Default Setup - CognitiveTPG A799 Setup Manual

Ethernet Interface Setup Guide

Ethernet Default Setup

To return the printer to the default settings, put the
hear the high-low-high tones (about 10 seconds).
The default settings are:
DHCP Enabled
Default IP 192.0.0.192 (in use after 2 minute Bootp time-out)
Net mask of 0.0.0.0 (causes default mask of selected IP to be used)
HTTP Server Port 80 active
Raw TCP/IP Port 9001 active
*** A799II - Diagnostics Form ***
Model number
Serial number
Flash Firmware
Revision
CRC
P/N
H/W parameters
Flash Memory Size
Flash Logos/Fonts
Flash User Storage
Flash Perm'nt Fonts : 5504 kbytes
Flash Journal Size
SRAM Size
Head settting
Motor ID
Paper Type Setting
Color Density Adj
Print Density, Mono
Max Speed
Paper Width
Max Power
Knife
Partial Cut
Paper Low Sensor
No Paper Low Extension
Comm. Interfaces
Interface
Ethernet Type
Parameters
MAC Address
IP Address
Net Mask
Gateway
Raw TCPIP Port
Loop Back Port
Http Server Port
DHCP
Client ID
Inactivity Timeout : Disabled
Keep Alive Pings
***To Enter Printer Con g Menu***
Press Feed Button Within the
Next Two Seconds
TPG-ETHSUG
printer in flash download mode and hold down the feed switch until you
: A799-780E-TD00
: 0000000000
: V1.27
: F755
: 189-799A127B
: 8 Mbytes
: 640 kbytes
: 0 kbytes
: 0 kbytes
: 8192 kbytes
: H
: 1
: Type 0, Monochrome
: n/a
: 80%
: 350 mm/sec
: 80 mm
: Level 1
: Enabled
: 135 steps
: Enabled
: Ethernet
: Wired
: 00:E0:70:00:50:2B
: 10.1.2.16
: 255.255.0.0
: 10.1.1.2
: 9001
: Disabled
: 80
: Enabled
: 00E070F04207
: Disabled
- Set Firmware Features
Sample diagnostic printout of an Ethernet printer
Highlighted area shows Ethernet settings.
These settings can not be changed through the configuration
menu and must be set by sending commands from the host.
See commands, beginning on the following page.
- > 8 clicks
Rev. G 4/2017
4