7. Service And Maintenance; 8. Failures - Axima CONTIS basic User Instructions

T
CON IS
basic

7. Service and maintenance

Caution!
The charger is an electrical device and should be handled with care!
Before any kind of handling of the charger (relocating, cover removal, disassembling components) the
device must be disconnected from the battery and from the mains supply. Servicing must only be carried out
by qualified personnel.
Regular inspection
After ensuring reliable operations, the following regular inspection routines are recommended:
• check individual charger components (output modules, ventilators etc.) for excessive dust levels. If these are found, it is essential to
remove this dust with compressed air. The output module should be cleaned in a direction away from the ventilator, placing the jet
of the air pistol between the ventilator blades and blowing air in all directions
• check mains supply cable and connector
• check output cable and battery connector
• check temp. sensor, the connected cable and its satisfactory placement on the battery
• check hoses of aeration system
• charger cover
In the event that any kind of fault is discovered, which undermines the safety of the charger or results in potential erroneous battery
charging, cease using the product and report the problem to maintenance personnel.
Caution!
High–voltage insulation testing is not permitted on the charger. This may lead to the destruction of
semiconductor components. Prior to undertaking wiring testing, the charger must be disconnected from the
mains supply.
Warranty
The charger is covered by a standard two year warranty from time of purchase.
In the event the product develops a fault, please contact your supplier.
Do not under any circumstances attempt to repair a faulty unit.

8. Failures

F10 - power units with different voltage levels has been connected together
F15 - voltage monitors of single modules connected in parallel vary more than 3% of Unom
F32 - the charging current >120% of the desired value, charging is stopped
F33 - the charging current >120% of the Inom – value, charging is stopped
4 7390 00 0
AXIMA, spol. s r. o., Vídeňská 125, Brno 619 00, CZ
tel.: +420 547 424 011 • fax: +420 547 424 030 • e-mail: acdc@axima.cz
7
STATION BATTERY CHARGER
Operating instructions
www.axima.cz