Preparing For Use; Baby Unit; Parent Unit - Philips AVENT SCD710 Manual

Introduction
Display of the parent unit (Fig. 1)

Preparing for use

Baby unit

Parent unit

Go to www.philips.com/welcome to register your product and to read the
detailed user manual.
1 Signal strength indicator
2 Eco Max indicator
3 Mute symbol
4 Battery status indicator
5 Microphone sensitivity indicator
6 Lullaby symbol
7 Nightlight symbol
8 Timer symbol
9 Temperature symbol
10 Navigation arrow
IMPORTANT: Read the safety instructions carefully before you use the
baby monitor and keep them for future reference.
We advise you to use the baby unit connected to the mains. To guarantee
automatic power backup in case of mains failure, you can insert four 1.5V AA
alkaline batteries (not included).
Do not use rechargeable batteries. The baby unit does not have a charging
function and rechargeable batteries discharge slowly when they are not in
use.
The parent unit runs on two rechargeable batteries that are supplied with
the baby monitor. Charge the parent unit before you use it for the first time
and when the batteries are low.
Please note that for the SCD710/SCD711/SCD713, you have to charge the
parent unit for the full 10 hours to have a cordless operating time of 18
hours. (For the SCD715: the charging time is 14 hours and the operating
time is 25 hours.
Note: When you start using the baby monitor, it takes 4 charge and
discharge cycles before the rechargeable batteries reach their full capacity.
English
7