Turning The Power On/Off - Kyocera TORQUE G04 Basic Manual

◎ If you move the product from its position after the
indicator LEDs have already lit blue, the product
may not charge or may take a long time to charge.
Remove the product, wait about 15 seconds, and
place again where the indicator LEDs light blue.
◎ If charging does not start, check that the back
cover is properly attached. Also check that the
charging connection under the back cover is not
soiled.
◎ Charging is controlled at a reduced rate during
wireless charging to prolong the life of the
battery pack.

Turning the Power On/Off

Turning the Power On
1
Press and hold F (Power button)
until the incoming light turns on
The start screen is displayed. (▶P. 71).
• For the first time you turn on the product,
the initial setting activates. Configure the
settings as necessary. For details, refer to
"Initial Settings" in the packaged "Setting
Guide".
◎ When logos are being displayed on the screen, do
not touch the screen because the initial setting of
the touch panel activates. Doing so may prevent
the touch panel from working properly.
◎ If you skip the operation of the initial settings at
the first start-up, you can set later.
69 69