Kyocera TORQUE G04 Basic Manual page 39

◦ If any liquid other than water gets on the
product
If anything other than water (washing detergent,
•
alcohol, etc.) gets on the product, immediately
rinse with water.
You can wash the product under a mild flow
•
(up to 6 liters per minute) of tap water at room
temperature (5℃ to 35℃) at a distance of about
10 cm from the faucet or showerhead.
If soiled, wash by hand without using a brush,
•
etc., holding the product so that the back cover
and USB cover do not open.
◦ After the product gets wet
After becoming wet, drain water, and then without
•
removing the back cover, wipe both the product
and back cover with a dry, clean cloth.
In cold regions, any water on the product may
•
freeze. Using the product with frozen water may
cause malfunction. Do not leave water drop on
the product.
◦ Rubber seal
The rubber seal around the back cover and
•
USB cover is important in maintaining water
resistance. Do not scratch or remove it.
38
Be careful not to pinch the rubber seal when
•
closing the back cover and USB cover. Trying to
close the cover with a seal pinched can scratch
the seal and affect water resistance. Any minute
particles becoming lodged between contact
surfaces (a single hair, etc.), no matter how small,
can cause seepage.
• Any liquid other than water (alcohol, etc.) on the
product can affect product durability.
Do not insert pointed objects in the USB cover
•
or back cover. Doing so may damage/deform the
product or scratch the rubber seal, allowing water
seepage.
Parts used for maintaining water resistance
•
should be replaced every 2 years regardless of
their appearance. Contact your nearest au shop
for replacement.
◦ Heat resistance
Do not submerge the product in hot water or get
•
it wet with hot water. Do not use the product in
saunas or expose it to hot air from hair dryer, etc.
The product is not designed to be heat resistant.
◦ Shock
The product shock resistance assumes usage
•
in daily situations; subjecting the product to
excessive shock such as by throwing or causing/
letting the product fall forcefully may break the
product.