ChemInstruments PT-2000 Operating Instructions Manual page 9

SETUP SCREEN
 Calibrate Load Cell – allows the user to calibrate the load cell.
 Units – change the force units and/or the speed units.
 Speed – set the test platform's test speed. If the mode is set to D 2979 then
speed is set to 24 in/min (or 10 mm/sec) and cannot be changed.
 Dwell – is used to select the dwell time. If the mode is set to D 2979 then dwell
time is set to 1 second and cannot be changed.
 Mode – sets the mode of test operation. D 2979 will set the speed and dwell
time specified in the test specification and will not allow the user to change these
two settings.
 Qualify Operation – is used verify some of the hardware functions with the PT-
2000.
 About – retrieve the machine's software version and control board's hardware
revision.
 Exit – go back to the main screen.
If there are 30 seconds of no screen activity when in any of the setup screens except
the qualify operation screen, then the machine will exit the setup screen and return to
the main screen.
Probe Tack Tester Operating Instructions (PT-2000)
9 | P a g e