Midland BT SINGLE Instruction Manual page 19

Description of the installation brackets
The Midland BT Single can be fixed onto the helmet in two
different ways: By either using the plate with bi-adhesive strip,
or the clamp. These methods allow you to safely "fix" the BT
Single unit onto your helmet and to remove it at any time in
order to recharge or store it.
Plate with bi-adhesive strip
The fixing plate has a bi-adhesive strip on one of its sides. To
fix the plate in place, clean the application area on the helmet
surface, remove the bi-adhesive film and place the fixing plate
on the helmet by keeping it contact with the surface for a few
seconds.
Clamp
Using the Allen Key, loosen the two screws on the clamp and
place the rear plate between the helmet padding and the ex-
ternal rigid protection. Then, tighten the two screws in order to
firmly fix the clamp in place.
Fitting and removing your Midland BT Single
The BT Single can be easily fitted onto the helmet by sliding
it downwards so that it fits into the slot of the selected fixing
device (plate with bi-adhesive strip or clamp).
BT Single is maintained in position thanks to the fixing clip
located on the upper section (A).
To detach the BT Single, simply press the fixing clip and push
the unit upwards.
5