During Operation; During Operating Safety - Toro TimeMaster 21199 Operator's Manual

2
1
Figure 15
Front cutting-height lever
1. A: 10.8 cm (4-1/4 inches)
2. B: 9.5 cm (3-3/4 inches)
3. C: 8.3 cm (3-1/4 inches)
4. D: 7.0 cm (2-3/4 inches)
3
2
1
Figure 16
Rear cutting-height lever
1. A: 10.8 cm (4-1/4 inches)
2. B: 9.5 cm (3-3/4 inches)
3. C: 8.3 cm (3-1/4 inches)
4. D: 7.0 cm (2-3/4 inches)
3
4
5
6
7
G017634
5. E: 5.7 cm (2-1/4 inches)
6. F: 4.4 cm (1-3/4 inches)
7. G: 3.2 cm (1-1/4 inches)
4
5
6
7
G017635
5. E: 5.7 cm (2-1/4 inches)
6. F: 4.4 cm (1-3/4 inches)
7. G: 3.2 cm (1-1/4 inches)

During Operation

During Operating Safety

General Safety
•
Wear appropriate clothing, including eye protection;
slip-resistant, substantial footwear; and hearing
protection. Tie back long hair, secure loose clothing, and
do not wear jewelry.
•
Do not operate the machine while ill, tired, or under the
influence of alcohol or drugs.
•
The blades are sharp; contacting the blades can result
in serious personal injury. Shut off the engine, remove
the ignition key (electric-start model only), and wait for
all moving parts to stop before leaving the operating
g017634 position.
•
When you release the blade-control bar, the engine should
shut off and the blades should stop within 3 seconds. If
not, stop using your machine immediately and contact an
Authorized Service Dealer.
•
Operate the machine only in good visibility and
appropriate weather conditions. Do not operate the
machine when there is the risk of lighting.
•
Wet grass or leaves can cause serious injury if you slip and
contact the blades. Avoid mowing in wet conditions.
•
Use extreme care when approaching blind corners,
shrubs, trees, or other objects that may block your view.
•
Watch for holes, ruts, bumps, rocks, or other hidden
objects. Uneven terrain could cause a slip-and-fall
accident.
•
Stop the machine and inspect the blades after striking an
object or if there is an abnormal vibration in the machine.
Make all necessary repairs before resuming operation.
•
Before leaving the operating position, shut off the engine,
remove the ignition key (electric-start model only), and
wait for all moving parts to stop.
•
If the engine has been running the muffler will be hot and
can severely burn you. Keep away from the hot muffler.
•
Check the grass catcher components and the discharge
guard frequently and replace them with the manufacturer's
recommended parts when necessary.
g017635
•
Use accessories and attachments approved by the The
Toro® Company only.
Slope Safety
•
Mow across the face of slopes; never up and down. Use
extreme caution when changing direction on slopes.
•
Do not mow on excessively steep slopes. Poor footing
could cause a slip-and-fall accident.
•
Mow with caution near drop-offs, ditches, or
embankments.
11