1. Manuals
  2. Brands
  3. Dru Manuals
  4. Indoor Fireplace
  5. Metro 130 XTL G20
  6. Installation manual

Dru Metro 100 XTL G20 Installation Manual

Hide thumbs Also See for Metro 100 XTL G20:
Table of Contents

Advertisement

Quick Links

Download this manual
Metro 100 XTL
G20/25
(GB / IE)
Installation manual
Store this document in a safe place
Dieses Dokument bitte sorgfältig aufbewahren
GB

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the Metro 100 XTL G20 and is the answer not in the manual?

Questions and answers

Related Manuals for Dru Metro 100 XTL G20

Summary of Contents for Dru Metro 100 XTL G20

  • Page 1 Metro 100 XTL G20/25 (GB / IE) Installation manual Store this document in a safe place Dieses Dokument bitte sorgfältig aufbewahren...

  • Page 2: Table Of Contents

    M E T R O 100 X T L - I N S TA L L AT I O N M A N UA L Contents page Preface 1. Introduction 2. CE declaration 3. SAFETY 3.1 General 3.2 Regulations 3.3 Precautions / safety instructions during installation 4.

  • Page 3: Preface

    This system can be installed through the wall or through the roof. These appliances are built within a chimney breast. For this, DRU has a number of chimney breasts in its range. In order to reach a proper heat discharge, the chimney breast must be ventilated. DRU is able to supply various ventilation elements.

  • Page 4: Safety

    200 cm ➠ only use the flue gas discharge / combustion air supply system supplied by DRU; ➠ mount the appliance using the wall brackets supplied;...

  • Page 5: Installation

    In appendix 1 / table 5 you can see which parts you should have after removing the packaging. ➠ Contact DRU Service if you do not have all the parts after you finished removing the packaging. ➠ Dispose packaging in accordance with local regulations.

  • Page 6: Flue Gas Discharge / Combustion Air Supply System

    Caution - Only use the concentric system supplied by DRU (Ø100 / Ø150 mm). This system has been tested together with the ap- pliance. DRU cannot guarantee a proper and safe operation of other systems and does not accept any liability for this;...
  • Page 7 M E T R O 100 X T L - I N S TA L L AT I O N M A N UA L 6.5.2 Application with wall terminal 6.5.2.1 Construction of concentric system with wall terminal The concentric system with wall terminal has to comply with the following conditions: - First, a concentric pipe of at least 0.5 meters should be connected vertically to the appliance;...
  • Page 8 M E T R O 100 X T L - I N S TA L L AT I O N M A N UA L 6.5.3 Application with roof terminal 6.5.3.1 Construction of concentric system with roof terminal The concentric system with roof terminal has to comply with the following conditions: - The construction of the chosen system has to be allowed.
  • Page 9 M E T R O 100 X T L - I N S TA L L AT I O N M A N UA L Table 2: Determination of the permissibility of a concentric system with a roof terminal G20/25 Total number of Total number of meters vertical and/or sloping pipe length meters horizontal...

  • Page 10: Placing The Chimney Breast

    - the measurements of the panes, so that they can be placed/removed after placing the chimney breast; - the protection of the gas control and the pipes against cement and plaster. !Tip - You should preferably apply the ventilation holes on both sides of the chimney breast. You can use DRU ventilation elements.

  • Page 11: Placing The Control Box

    M E T R O 100 X T L - I N S TA L L AT I O N M A N UA L ➠ Check whether the concentric system is placed correctly. ➠ Check the fixture of the clip binding with self-tapping screws on places that cannot be reached later on. ➠...

  • Page 12: Placing The Wood/Pebble Set

    M E T R O 100 X T L - I N S TA L L AT I O N M A N UA L 6.8.1 Baffle (R) The baffle (R) is supplied separately; see fig. 11a. This is mounted as follows (see fig. 11b): ➠...

  • Page 13: Panes

    After placing the wood/pebble set you can place the front pane as described below. !Caution - The DRU logo should be at the bottom right corner; - The self-tapping screws must not be over-tightened, since otherwise they could break or strip the thread: tight=tight;...

  • Page 14: Wireless Remote Control

    Placing the front pane will take place in reverse order of the removal procedure described above. !Caution - The DRU logo should be at the bottom right corner; - The self-tapping screws must not be over-tightened, since otherwise they could break or strip the thread: tight=tight;...

  • Page 15: Final Check

    M E T R O 100 X T L - I N S TA L L AT I O N M A N UA L 7.1.1 Placing / replacing the batteries Follow the procedure below when placing the batteries: ➠ Open the door of the control box.

  • Page 16: Flame Image

    M E T R O 100 X T L - I N S TA L L AT I O N M A N UA L 8.3.2 Main burner Caution The burner should ignite smoothly and should not pop as a result of delayed ignition. ➠...

  • Page 17: Maintenance

    M E T R O 100 X T L - I N S TA L L AT I O N M A N UA L Maintenance Once a year the appliance should be checked, cleaned and, if necessary, repaired by a competent installer in the field of atmospheric gas-fired heating.

  • Page 18: Malfunctions

    M E T R O 100 X T L - I N S TA L L AT I O N M A N UA L 11. Malfunctions In the following table you will find an overview of malfunctions that might occur, the possible causes and the remedies.
  • Page 19 M E T R O 100 X T L - I N S TA L L AT I O N M A N UA L Table 4: Diagnosis of malfunctions Problem Possible cause Remedy E. No pilot burner flame 1. Air in the pilot burner pipe. 1.
  • Page 20 M E T R O 100 X T L - I N S TA L L AT I O N M A N UA L Table 4: Diagnosis of malfunctions Problem Possible cause Remedy J. Main burner ignites, 1. Wiring of thermocouple 2 is 1.

  • Page 21: Appendix 1 Parts Included With The Delivery

    M E T R O 100 X T L - I N S TA L L AT I O N M A N UA L Appendix 1 Parts included with the delivery In the following table you can find the parts that are supplied with the appliance. Table 5: Parts included with the delivery Part Quantity...

  • Page 22: Appendix 3 Figures

    M E T R O 100 X T L - I N S TA L L AT I O N M A N UA L Appendix 3 Figures...
  • Page 23 M E T R O 100 X T L - I N S TA L L AT I O N M A N UA L...
  • Page 24 M E T R O 100 X T L - I N S TA L L AT I O N M A N UA L...
  • Page 25 M E T R O 100 X T L - I N S TA L L AT I O N M A N UA L 38c-1078...
  • Page 26 M E T R O 100 X T L - I N S TA L L AT I O N M A N UA L...
  • Page 27 M E T R O 100 X T L - I N S TA L L AT I O N M A N UA L...
  • Page 28 M E T R O 100 X T L - I N S TA L L AT I O N M A N UA L...
  • Page 29 M E T R O 100 X T L - I N S TA L L AT I O N M A N UA L...
  • Page 30 M E T R O 100 X T L - I N S TA L L AT I O N M A N UA L...
  • Page 31 M E T R O 100 X T L - I N S TA L L AT I O N M A N UA L Notes ....................................................
  • Page 32 M E T R O 100 X T L - I N S TA L L AT I O N M A N UA L DRU Verwarming B.V. The Netherlands Postbus 1021, NL-6920 BA Duiven Ratio 8, NL-6921 RW Duiven...

This manual is also suitable for:

Metro 100 xtl g25

Table of Contents