Advertisement
GB
Loading and Airflow
Distribute the load evenly and make sure that it doesn't exceed the maximum amounts stated below.
Slimline NG & RF Models
330ml Drink Can Capacity
Pro NG & RF Models
330ml Drink Can Capacity
(Calculated as a single stack of cans per shelf
Make sure air can circulate around & through the product do not cover the base shelf's front grill. Maintain
space between the top of the product and the shelf above. Product must be cold before loading -
Multidecks are designed to maintain the merchandise temperature and not chill product from room
temperature.
Shutters & Nightblinds
Shutters are slatted solid covers that roll down in a single motion and then retract by being pushed
upwards. To avoid damage, do not let go of the shutter when opening or closing. To lock insert the key &
turn through 180° until you hear the lock click into place (keys should be kept out of the reach of the
general public & especially children).
Nightblinds are fabric covers without locks and pull down in a single, smooth motion; a mechanism in the
roller and a securing latch on the front of the unit then stops the blind from retracting.
To retract, simply unhook the blind from the front securing latch and pull down gently on the blind, which in
turn triggers the mechanism to retract back up towards the top of the unit. To avoid damage, guide the blind
when retracting by gently holding onto the blind handle.
When the Multideck is not required to display product, the shutter or blind should be closed fully.
This will conserve energy used by the unit, maintain product temperature and hide merchandise from view.
Defrost
The Multideck automatically defrosts at regular time intervals, lasting a maximum of 20 minutes during
which
will show. Defrost can be manually activated by pressing and holding
Cleaning and Maintenance
Important: Before cleaning the power supply should be turned off at the mains, please do not plug
or unplug the unit with wet hands. Only when cleaning has been completed and the unit is dry may
the Multideck be turned back on at the mains.
Regular Maintenance:
Air circulating in the unit should feel noticably cooler than the ambient temperature.
As and when required, remove all product and shelving from the unit (including the base shelf –
beware of cold and or sharp components) . Clean exterior and interior surfaces with mild liquid
detergent, following the directions on the pack at all times. Clean surfaces with a damp cloth and
clean water. Never use wire wool or scouring pads/powders as these may cause damage.
Clean the condenser at least once a month (it is located behind the front grille). Remove the 3
screws at the base of the panel and drop it downwards (beware of hot and possible sharp
components behind the grille). DO NOT use a wire brush to clean the condenser only use a soft
brush or vacuum cleaner to remove dirt/dust. If there are any stubborn grease deposits left on or
through the condenser, call your supplier to carry out a full service (this is normally a chargeable
service). Re-fit the front grille after cleaning.
Failure to maintain the condenser will cause premature failure of the motor/compressor and in turn
cause premature failure of the unit. This will invalidate the warranty of the unit and its parts.
700
900
216
288
(54 per shelf)
(72 per shelf)
900
420
(84 per shelf)
)
1200
1500
384
504
(96 per shelf)
(126 per shelf)
1200
1500
560
735
(112 per shelf)
(147 per shelf)
1800
624
(156 per shelf)
1800
910
(182 per shelf)
.
Advertisement
