Advertisement
GB
Function Icons and Buttons/Switches
Info/Set point Button
Increase Button/ Lights On/Off
Manual defrost /Decrease Button
Exit/Stand-by Button
Compressor Output
Alarm
Fan Output
Defrost Output
Light Output
Set Point Display
Press button
briefly (at least half a second) to display the set point.
Keypad Security Settings
to show 'LOC'. Press and hold
to change from 'YES' to 'NO'. Leave
Press & release
then select
for 10 seconds or briefly press
to resume to normal operation.
Internal Light
When pressed and released this button will switch on and off the display lights, with the unit running or in
standby mode. If the lights do not come on this may be due to a fault warning, please see the
troubleshooting section for more details.
Shelves and Supports
On delivery of the Multideck these parts are supplied wrapped
inside the unit on the base shelf. These will require cleaning and
fitting at first install.
Supports can be fitted at three different angles, allowing the shelf to
be tilted or level. Each shelf requires two supports (unless on a 1500
or 1800 model then a third centre support is also required).
Slot the first support into one side of the ladderacking at the height
and angle the shelf will be required. Repeat this on the opposite side
at the same position and angle (do the same for the centre support if applicable).
Always remember that you will need to allow for breathing space around, not only the shelves, but the
product. Remember to leave enough space between the supports when positioning on the ladderack.
Shelves are fitted once the supports are in place. Hold the shelf level and above the supports making sure
the flat surface is facing upwards. Position the supports so that they sit in the recess between the edge of
the shelf and central moulding. When positioned correctly the shelf will drop down onto the supports and be
secure.
The base shelf will already be fitted but can be removed by lifting straight up and away. This does not have
any supports and should not be removed when the unit is energised.
Ticket Strips can be fitted when shelves are in situ or before fitting.
These plastic mouldings are placed on the front of each shelf by firstly
hooking underneath then once gripped pushing onto the shelf facet in
an upwards motion. Make sure that all of the strip has secured itself
to the shelf and is secure.
All these parts are removable by carrying out the above instructions in
reverse. This should be carried out at regular intervals for cleaning
purposes.
Advertisement
