Advertisement
GB
Important Note to the Installer:
If you are not the user please pass this document on to them as it contains
important guidelines on operation, loading, cleaning and general
maintenance and should be kept for reference.
General Electrical Safety
Foster Refrigerator recommends that the equipment is electrically connected via a Residual Current
Device; such as a Residual Current Circuit Breaker (RCCB) type socket, or through a Residual Current
Circuit Breaker with Overload Protection (RCBO) supplied circuit.
Disposal Requirements
If not disposed of properly all refrigerators have components that can be harmful to the environment. All old
refrigerators must be disposed of by appropriately registered and licensed waste contractors, and in
accordance with national laws and regulations.
Start-Up and Operation
After unpacking leave to stand for 60 minutes and clean before turning on (cleaning directions are
supplied within this manual). Position the Multideck with care on a level, flat, solid surface area.
Avoid cold air from air conditioning units & direct sunlight as these factors will affect the units' performance.
Warm air is produced from the rear of the unit & for this reason please leave a breathing area around the
unit as follows:
Gap Position
Each Side of the Unit to Wall or next Unit.
Top of Unit to Ceiling (No Rear Ventilation)*
Top of Unit to Ceiling (With Rear Ventilation)
Rear of Units Wall Spacer to Wall
Rear of Units Wall Spacer to Wall
*When positioned into a recess or similar small area.
Insert the mains plug into the wall socket and switch on. Please do not plug or unplug the unit with wet
hands. The Multideck will start automatically, displaying the actual internal temperature of the unit (area
where product is displayed). All models are pre-set at +3° C to +5°C, so no adjustments are required.
Allow the Multideck to reach its normal operating temperature before loading.
With an interruption to the main power supply, the Multideck will re-start automatically after power is
restored. The vaporiser tray (at the base of the unit) may overflow during a power cut but this is dependent
on the length of time the power is off.
Standby
Pressing this button for 3 seconds will allow the unit to be turned on or put into standby.
Display Icons and Switches
Functions Icons
Temperature Display
Gap Measurement
10mm
80mm
10mm
60mm
20mm
Buttons/Switches
Relevant Models
Slim & Pro
Slim & Pro
Slim & Pro
Slim
Pro
Advertisement
