xLab TORPEDO VERSA 200 Instruction Sheet

IMPORTANT:
PLEASE COMPLETELY UNDERSTAND ALL USER INSTRUCTIONS AND SAFETY INFORMATION BEFORE USING THIS PRODUCT. AS WITH ANY HIGH TECH PRODUCT YOU WILL NEED TO
ROUTINELY CHECK FOR LOOSE HARDWARE, CRACKS OR OTHER DAMAGE AND REPLACE ITEMS AS NECESSARY. DO NOT USE PRODUCT IF ANY OF THESE CONDITIONS EXIST.
HARDWARE
CAGE MOUNTING
M5 x 12mm M5 x 16mm
Socket Head Socket Head
COMPUTER MOUNT
M4 x 10mm
M5 x 25mm
Button Head Screw
Flat Head Screw
(x2)
AERO COMPUTER MOUNT
M5 x 16mm M5 Fender Washer
Button Head
Flange Screw
MOUNTING TO BIKE
TOOLS REQUIRED
3mm Hex Wrench
Torque Wrench up to 35 in lbs (4.0 Nm)
1. Rotate the top of the computer mount all the way forward.
2. Remove the Torpedo Bottle from the cage by holding the
mount and twisting the bottle and pulling out.
3. Loosen the mounting clamp screws using the 3mm Hex Wrench.
M5 Flat Washer M5 Nylon Insert
(x2) Lock Nut (x2)
M3 x 6mm
Screw Post / Screw
Flat Head Screw
(x2)
M5 Flat Washer M5 Nylon
Insert Lock Nut
TORPEDO VERSA 200
TORPEDO VERSA 200
MOUNTING CLAMP
M5 Nylon Spacer
M5 x 8mm Button Head
Flange Screw (x2)
BOTTLE
Spring
M4 x 20mm
Flat Head Screw
M5 External
Lock Washer
4. Place the mount on the aerobars by pressing each of the mounting
clamps onto the extensions. The mounting clamp is designed to
expand around the extensions and snap in place.
Ensure the clamp is completely touching the extensions.
5. Center the mounting plate and hand tighten each of
the screws.
6. Secure the Velcro straps by routing them through the clamps.
Pull the straps as tight as possible and attach them in place.
7. Tighten both mounting clamp screws to 35 in lbs (4.0 Nm).
Dolphin Breather Valve
(x2)