Related Manuals for Dixon Holedall 25 Ton Ram
Summary of Contents for Dixon Holedall 25 Ton Ram
- Page 1 25 Ton Ram Operating Instructions Section 2 External Swaging of Standard Holedall Dixon Valve & Coupling Company 800 High Street • Chestertown, MD 21620 ph: 800•355•1991 fax: 800•283•4966 www.dixonvalve.com...
- Page 2 25 Ton Ram Instruction Manual Externally Swaged Holedall Before you begin, make sure the ram is fully retracted. Install 25PUSH400 (also referred to as the pusher hat) onto the main pusher plate. This is required for all standard Holedall fittings. Make sure the bolt holes align with the 1/2”...
- Page 3 Lubricate the I.D. of the hose and the O.D. of the stem with Dixon lubricant or equivalent. Insert the stem all the way into the hose until the ring on the stem comes in contact with the end of the hose.
- Page 4 25 Ton Ram Instruction Manual Externally Swaged Holedall Lubricate the I.D. of the die halves with Crisco® (recommended) or a high viscosity oil or heavy duty grease. Insert the hose fitting assembly through the bottom of the ram (between the die holders) far enough to allow room to install the die halves into the die holder.
- Page 5 Externally Swaged Holedall Note: If the gauge reads 10,000 PSI before swaging is complete, stop. The ferrule or die used for that hose end may be incorrect. Contact Dixon for further assistance. Dixon Valve and Coupling Company recommends that all hose assemblies be tested as recommended by the Rubber Manufacturers Association.
- Page 6 25 Ton Ram Instruction Manual Externally Swaged Holedall Typical Setup - 25 Ton Ram, External Swaging Section 2 customer service 800•355•1991...