Specifications - Philips MCM118D/37B Owner's Manual

Troubleshooting
WARNING
Under no circumstances should you try to repair the system yourself, as this will invalidate the
warranty. Do not open the system as there is a risk of electric shock.
If a fault occurs, first check the points listed below before taking the system for repair. If you are
unable to remedy a problem by following these hints, consult your dealer or service centre.
Problem
CD OPERATION
"NO cd" is displayed.
RADIO RECEPTION
Radio reception is poor.
GENERAL
The system does not react when
buttons are pressed.
Sound cannot be heard or is of poor
quality.
The left and right sound outputs are
reversed.
The remote control does not function
properly.
The timer is not working.
The Clock/Timer setting is erased.
20
Solution
– Insert a disc.
– Check if the disc is inserted upside down.
– Wait until the moisture condensation at the lens
has cleared.
– Replace or clean the disc, see "Maintenance".
– Use a finalised CD-RW or CD-R, or a correct
MP3-CD format disc.
– If the signal is too weak, adjust the antenna or
connect an external antenna for better reception.
– Increase the distance between the Micro HiFi
System and your TV or VCR.
– Remove and reconnect the AC power plug and
switch on the system again.
– Adjust the volume.
– Disconnect the headphones.
– Check that the speakers are connected correctly.
– Check if the stripped speaker wire is clamped.
– Make sure the MP3-CD was recorded within
32-256 kbps bit rate with sampling frequencies
at 48 kHz, 44.1 kHz or 32 kHz.
– Check the speaker connections and location.
– Select the source (CD or TUNER, for example)
before pressing the function button (É,í,ë).
– Reduce the distance between the remote control
and the system.
– Insert the batteries with their polarities
(+/– signs) aligned as indicated.
– Replace the batteries.
– Point the remote control directly toward
IR sensor on the front of the system.
– Set the clock correctly.
– Press TIMER to switch on the timer.
– Power has been interrupted or the power cord has
been disconnected. Reset the clock/timer.
Troubleshooting
DOCK OPERATION
The menu navigation or photo
playback of the docked player cannot be
carried out through the buttons on
MCM118D or its remote control.
The STOP 9 and some buttons on
MCM118D and its remote control
have no function.
The battery of my Philips GoGear in
dock is drained when it is not
used for playback.

Specifications

AMPLIFIER
Output power .................................................... 2 x 15W
.................................................................. 30W total power
.................................................................. 2 x 12W FTC 1
Signal-to-noise ratio .......................... ≥ 62 dBA (IEC)
Frequency response ...... 125 – 16000 Hz, ± 3 dB
Impedance loudspeakers ......................................... 4 Ω
Impedance headphones ........................................ 32 Ω
Note:
,
1(4Ω
60Hz~12.5kHz, 10%THD)
CD PLAYER
Frequency range .................................. 20 – 20000 Hz
Signal-to-noise ratio ............................................ 62 dBA
TUNER
FM wave range ................................... 87.5 – 108 MHz
AM wave range .................................. 530 – 1700 kHz
Sensitivity at 75 Ω
– mono, 26 dB signal-to-noise ratio ............ 3.8 µV
– stereo, 46 dB signal-to-noise ratio ........ 61.4 µV
Selectivity ................................................................. ≥ 28 dB
Total harmonic distortion ..................................... ≤ 5%
Frequency response ..... 63 – 12500 Hz (± 3 dB)
Signal-to-noise-ratio .......................................... ≥ 50 dB
– The buttons on MCM118D and its remote
control can control playback of audio contents
only. To navigate the menu, use the controls on
the docked player.
– The playback of the docked player cannot be
stopped using the STOP 9 button on
MCM118D and its remote control.
– The buttons ( 2;, ¡1, 2™ and VOLUME )
function only.
– The docked GoGear is still comsuming battery.
power it off if you don't use the player.
SPEAKERS
Bass reflex system
Dimensions (w x h x d) . 150 x 150 x 200 (mm)
GENERAL INFORMATION
AC Power .................................................... 120V / 60 Hz
Dimensions (w x h x d) .. 150 x 150 x 220 (mm)
Weight (with/without speakers) ..................................
............................................................... approx. 4.9 / 2.3 kg
ECO power consumption ................................ < 1 W
Subject to modification
21