Replacing Battery (Lithium Cr2032) Into The Remote Control - Philips MCM118D/37B Owner's Manual

Preparations
FM wire antenna
Speaker
(right)
AC MAINS~
IMPORTANT!
– Do not connect Mini-USB port both
on the main unit and the supplied dock
to a computer or any other USB devices.
It is only for connecting the supplied
dock and the main unit to let them work
together. See the Dock section for dock
connection.
Rear connections
The type plate is located at the rear of the
system.
A A A A A
Power
– Before connecting the AC power cord to the
wall outlet, ensure that all other connections
have been made.
WARNING!
– For optimal performance, use only the
original power cable.
– Never make or change any connections
with the power switched on.
10
AM loop antenna
Speaker
(left)
FM
DOCKING IN aerial
L R
RIGHT LEFT
AC power cord
B B B B B
Antennas Connection
AM (MW) antenna
1
Unfold the loop antenna and if necessary, use
screws (not supplied)to fix it to a flat, hard and
stable place:
1
2
2
Fit the plug of the loop antenna to AM
ANTENNA as shown above.
3
Adjust the antenna for optimal reception
FM Antenna
It is unnecessary to connect the FM pigtail
antenna since it is fixed to the main unit.
Position the antenna as far as possible from a TV,
VCR or other radiation source.
Preparations
C C C C C
Speakers Connection
Front Speakers
Connect the speaker wires to the SPEAKERS
terminals, right speaker to "RIGHT" and left
speaker to "LEFT", the wire (marked red) to
"+" and the wire (marked black) to "-".
Fully insert the stripped portion of the speaker
wire into the terminal as shown.
Notes:
– For optimal sound performance, use the
supplied speakers.
– Do not connect more than one speaker to any
one pair of + / - speaker terminals.
– Do not connect speakers with an impedance
lower than the speakers supplied. Please refer to
the SPECIFICATIONS section of this manual.
Before using the remote control
1
Pull out the plastic protective sheet.
2
Select the source you wish to control by
pressing one of the source select keys on the
remote control (for example CD, TUNER).
3
Then select the desired function (for example
É, í, ë).
Replacing battery (lithium
CR2032) into the remote control
1
A
Pull out the knob slightly to the left.
2
B
Pull out the battery compartment .
3
Replace a new battery and fully insert the
battery compartment back to the original
position.
CAUTION!
Batteries contain chemical substances, so
they should be disposed off properly.
11