Connecting A Single Drive - HP StorageWorks DLT VS 40 Reference Manual

External Tape Drive Installation

Connecting a Single Drive

If the selected server does not already have an LVD/SE SCSI host adapter
installed, install one now.
To connect the SCSI and power cables:
1. Shut down the operating system and power off the selected server. Turn off all
2. Remove the SCSI cable from the accessories package and locate the external
Note:
connection to a 68-pin VHDCI HBA, which will accommodate most servers. If your HBA
does not have a 68-pin VHDCI connector, you will need to purchase a separate cable.
Refer to the Quick Specs at
Note:
included with your server.
24
attached peripherals such as printers and other SCSI devices. Remove the
power cable from the host server and all attached peripherals.
Caution: Failure to follow these instructions could result in damage to the DLT
VS 40/80 GB tape drive or other devices.
SCSI port on the rear of the server.
The SCSI cable included with the DLT VS 40/80 GB tape drive allows
Your server may differ from the following illustrations; refer to the documentation
http://www.hp.com for cable option part numbers.
DLT VS 40/80 GB Tape Drive Reference Guide