Table of Contents
Advertisement
Each time you press one of these buttons, the SCSI ID decreases or increases by
one. Press the appropriate button until the desired SCSI ID appears on the switch
display.
Note:
SCSI ID above 6 is not recommended.
Figure 3: SCSI ID switch
Note:
drive off and on again for the new SCSI ID to take effect.
DLT VS 40/80 GB Tape Drive Reference Guide
SCSI ID 7 is reserved for the controller. The SCSI ID can be set up to 15, but a
1
2
If the drive is powered on when you change the SCSI ID, you must power the
External Tape Drive Installation
23
Advertisement
Table of Contents
