Advertisement
6.
Transmitting
[ PTT ]
To transmit depress and hold the key [ PTT] ( 1 ). The TX control LED ( 11 ) lights up in red
colour. The sensitivity of the microphone ( 15 ) has been set to give good results speaking
normally at a distance of 2 - 4 inches. Speaking too loudly will cause distortions and make
the signal difficult to understand. While the set is in the transmit mode there is no key entry
possible and the receiver is muted. On completion of the transmission release the PTT key
and the set will revert to receiving mode. The RX LED ( 12 ) now lights up in green colour.
7. Channel Scanning [ SCAN ]
Before selecting the SCAN function set the squelch control [ SQUELCH ] ( 8 )according
to Para" 2 " because this function does not work with unmuted receiver. Depress now the
key [ SCAN ] ( 7 ). In the display the channels arestepping upwards. SCAN stops on the
first occupied channel, where a signal can trigger the squelch threshold. The SCAN func-
tion is terminated now.
8.
Channel 9 [ CH9 ]
The priority channel 9 can be quickly selected by pressing the key [ CH9 ] ( 5 ). The chan-
nel number 9 lights up in the channel LED-display. No other funetion except transmitting
can be entered as long as the CH9 function is switched ON. Pressing CH9 again will can-
cel the function and the unit returns to the previous selected channel.
9. Cali Tone
lf you press the cali key ( 4 ) a cali tone will be transmitted and can be heard by the partner-
station providing it is switched on the same channel and same mode.
10. External Speaker Jack [EXT-SP]
The TS-TwoWay has a 3.5 mm phone socket ( 17) on the rear panel to conneet an exter-
nal speaker of 4 - 8 ohm impedance. AtA ohms the speaker load can be up to 4 watts
( e.g. TEAM TS-500 ). When the external speaker is connected the internal speaker will
be switched off.
11. External Signal Meter Jack [S-METER]
The TS-TwoWay offers also on its rear panel a socket ( 18 ) [ S-METER]
to conneet an
external S-meter with a 2.5 mm plug. Please note that the external S-meter shows only
the relative fieldstrength
of the incoming signal. The signal strength of a received station
can be either measured with a S-meter or estimated by the own impression. For the eval-
uation of the received signal there are 9 S-steps available. One S-step more is the same
as an increase of 6 dB. This means that the input signal strength at S3 is twice as high as
at S2. The 5 R-values can be used to inform the counter station about the sound quality
of the transmission.
Specifictions
are subject to change without any prior notice or obligation on the part of the manufacturer.
English
Safety Instruction
Drivers must keep attention about traffic rules by using the transceiver in a vehicle. Drivers
should use a handsfree microphone while driving.
The unit radiates RF energy in transmit mode. Please keep an eye on safety distance to
the antenna.
Servicing
The device must not be opened. Independent repairs or adjustment must not be carried out,
since each modification or unauthorised intervention will result in the cancelling of the oper-
ating permit and of the guarantee and repair claims.
Do not use the set if it seems not to function correctly. Disconnect the set from the DC power
source immediately.
If there is a defect, the authorised TEAM specialist dealer or TEAM
must be contacted in eve ry case.
General Precautions
Protect the set from humidity and dust. Do not store at places or in the sun where the tem-
perature may rise and cause damage. The set can be cleaned by wiping with a soft cloth.
Do not use chemical products to c1ean the set.
Approvals
The type TS-TwoWay 4000 is approved according to the European standard ETS 300 135.
It is intended to be put into circulation in the following european countries: Austria, Belgium,
Croatia,
Czech
Republic,
Denmark,
Finland,
France,
Germany,
Hungary,
Italy, The
Netherlands,
Norway,
Lithuania,
Luxemburg,
Repulic
of Slovenia,
Spain,
Sweden,
Switzerland,
United Kingdom.
The type TS-TwoWay 4040 is additionally
approved under ETS 300 433. The type TS-
TwoWay 4040 is approved for use in Switzerland only. TS-TwoWay 4040 is for distribution
and sale in: Belgium,
Finland, France,
Germany,
Poland,
Portugal,
the Netherlands,
Republic of Slovakia
Advertisement
