Table of Contents
Advertisement
RECOMMENDED ADJUSTMENTS
INSTALL THE AUXILIARY/END TABLE
Install the auxiliary/end table on the right side of
machine when you need support for sanding rounded
or curved workpieces.
Tip: The dust hood cannot be properly closed or fully
used when the auxiliary table is installed, therefore
whenever the table is not required remove it and set it
aside in order to maximize dust collection efficiency by
allowing you to close and make full use of the dust
hood. The auxiliary/end table is very easy to install or
remove when needed by simply loosening (or tighten-
ing) the lock knob holding it in place on the bracket
and then removing it from (or installing onto) the
bracket.
1. To install the table in its bracket, the dust hood must
be moved by unscrewing both the large
small
knobs and moving the dust hood towards
the back
. Screw the small knob
prevent the piece from moving.
ADJUST THE HEIGHT OF THE MAIN TABLE
Adjusting the height of the table allows an even wear-
ing of the sanding belt surface.
Loosen the two lock knobs
sanding head, then adjust the table height and tighten
the knobs to lock the table in position.
Tip: To maximize belt usage when working with shorter
work pieces, periodically adjust the table height to sys-
tematically make use of various portions of the belt. For
example; a series of 2" tall workpieces can be separat-
ed into 3 smaller batches with each batch being sand-
ed with the table set at different heights to use in
sequence the lower, middle or upper portion of the belt.
and
back in to
, which are under the
2. Insert the table rod
table
and tighten using the bolt and nut, which
are already mounted
3. Place the table rod assembly into the table brack-
et
. Insert a medium lock knob into the hole in the
table bracket to keep it in place
Tip: Align the flat surface of the table rod with the hole
in the table bracket, a flat surface offering a better grip
for the toggle screw than a rounded one.
in the opening under the
.
.
13
Advertisement
Table of Contents
