Recommended Adjustments - General 15-220 Setup And Operation Manual

SELECTION GUIDE FOR TABLE INSERTS
This machine is supplied with 5 spindles, and four table
inserts. The spindle diameters range from 1/4" to 2".
When changing spindles, the table insert will need to
be changed to the matching size. Each plate has
notch ( ) to fit the alignment pin (
ensure that it is properly fitted and installed in the table
opening.
FAILURE TO USE THE PROPER INSERT WITH THE CORRESPONDING SPINDLE MAY RESULT IN INJURY AND/OR DAMAGE TO
THE MACHINE OR THE WORKPIECE.
The following chart explains which inserts can be used for different diameter spindles.
SPINDLE DIAMETER
1/4" . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .#86
1/2" . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .#86
5/8" . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .#86
1-1/2" . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .#85
2" . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .#85

RECOMMENDED ADJUSTMENTS

SETUP FOR 90º SANDING
Step 1
Loosen both locking levers, position the table at 0° and
re-tighten the locking levers.
10
There are 2 insert plates with oblong openings and 2
with round openings. The oblong insert plates are
used when the table is tilted for bevel sanding.
) in the table to
Step 2
With a spindle installed, place a square on the table.
Rest the long section of the square against the
sanding spindle. The square should be flat against
the table and the spindle from all four sides.
TABLE INSERT (OPENING SHAPE/SIZE)
& #87
(ROUND) (OBLONG)
& #87
(ROUND) (OBLONG)
& #87
(ROUND) (OBLONG)
& #84
(ROUND) (OBLONG)
& #84
(ROUND) (OBLONG)
-SMALL
-SMALL
-SMALL
-LARGE
-LARGE