General 15-005S Setup & Operation Manual page 10

3. Remove the sanding belt
are stored in the sanding head. Put the fence aside
for now.
5. Install the sanding belt guard
rear supports – secure the left side only for now,
using a short lock knob and a large flat washer, as
shown above .
Note: Raise the guards so that the lock knobs can be
tightened at the top of the rear supports, to facilitate
the upcoming assembly steps (so that the dust hood
will not rub or bump against the motor).
10
and the fence that
between the 2
Tight - Loose
4. Install the handle onto the belt tension lever
install or change the sanding belt, simply pull the
belt tension lever to the "loose" position
install the sanding belt
tension lever back to the "tight" position.
6. Fit the left drum guard
and the belt guard
large flat washer and short lock knob
7. Attach the right drum guard
with 3 flange screws
. To
. Then
and reposition the belt
between the support
just installed, using another
.
on the dust hood
.