Table of Contents
Advertisement
ASSEMBLY INSTRUCTIONS
ASSEMBLE THE BASE
1. Using a bolt, washer, and a nut, attach 2 rubber
feet
to the side panels (2)
order of assembly
mm hex socket or 12 mm Allen key.
stopper washer
nut
3. Install the door handle
ing the order illustrated in figure
between both door supports, first by inserting the
rod into the hole of the lower door support
then, by pulling down on the spring lever
placing it in the hole of the upper door support.
5. Install the back panel
medium flat washers, lock washers and nuts
one on each side.
8
bolt
rubber
foot
washer
nut
according to
. Tighten nuts with either a 12
on the door
by follow-
. Install the door
, and
using 2 carriage bolts,
2. Attach the upper
the side panels
riage bolts, medium flat washers, lock washers and
nuts.
Note: Make sure the hole in the upper door support
faces downward
support faces upward
inserted into the lower door support and the spring
lever can be inserted into the upper door support.)
4. Install the door stopper
small square head screwdriver.
,
6. Place the shelf in the base and secure using 2
screws, medium flat washers and lock washers.
,
and lower
door supports to
, shown above, using the car-
, and the hole in the lower door
(so that the table rod can be
with 2 screws
, using a
Advertisement
Table of Contents
