Related Manuals for Duro Dyne LS-5
Summary of Contents for Duro Dyne LS-5
- Page 1 LS-5 LS-5 Duct Liner Sizer Duct Liner Sizer DUCT LINER DUCT LINER DUCT LINER DUCT LINER SIZER SIZER MACHINERY MACHINERY DIVISION DIVISION OWNER’S MANUAL...
- Page 2 ASSEMBL Y INSTRUCTIONS IMPORTANT: DO NOT TIGHTEN THE NUTS UNTIL 3) Insert the crank handle onto the lower drive THE UNIT IS COMPLETEL Y ASSEMBLED. roller shaft. Tighten the set screw. C) Place one 12” octagon sheet metal collar on A) Assemble the cutting frame with the legs as each piece of 1”pipe.
- Page 3 BLADE REPLACEMENT & ADJUSTMENT INSTRUCTIONS Diagram IV Diagram V Sitting Assembly Cross Cut Asembly Thumbscrew Knob Handle Hex Head Screw Hex Head Screw Blade Holder Bar Blade Holder Bar Locking Nut Shoulder Screw Slitting Blade Blade Roller IMPORTANT: THE BLADE IS VERY SHARP; USE 2) Attach the blade to the holder bar using the CARE IN MAKING ADJUSTMENTS.
-
Page 4: Parts Location
PARTS LOCATION Slitting Assembly (With Blade Roller) #28015 28066 Slitting Blade Thumbscrew Knob 28025 Slitter Support Casting 28026 Hub Blade 28009 28027 Spring Hold-Downs (with hub) #28013 28030 Blade Roller Slitter Drive Shaft (not included in #28015) 4’ #28028 5’ #28029 Liner Spool 4’... -
Page 5: Parts Identification
PARTS IDENTIFICATION Liner Spool Cross Cut Handle Cross Cut Assembly 4’ #28018 4’ #28072 (without handle) 5’ #28019 5’ #28073 #28012 Frame Only Slitting Assembly 4’ #28022 (With Blade Roller) 5’ #28023 #28015 Crank Handle #28014 Cutting Head (Top View) Idle Roller Measuring Tape Cross Cut Assembly... -
Page 6: Adjustments & Maintenance
Any component found to be defective will be repaired or replaced, at manufacturer’s discre- tion, at no cost, if faulty component is returned freight prepaid to the nearest Duro Dyne Service Department. Warranty does not apply to expend able parts, cutting blades, etc, of repairs, due to improper maintenance or operational procedures.
Need help?
Do you have a question about the LS-5 and is the answer not in the manual?
Questions and answers