Filling With Dishwasher Salt - Electrolux ESF 63020 User Manual

6 electrolux
Setting electronically
The dishwasher is factory set at level 5.
1. The dishwasher must be switched off.
Keep the start/cancel button pressed
and turn the programme knob clockwise
until the programme marker corresponds
with the first washing programme.

Filling with dishwasher salt

Warning!
Only use salt specifically designed for use in
dishwashers. All other types of salt not spe-
cifically designed for use in a dishwasher, es-
pecially table salt, will damage the water soft-
ener. Only fill with salt just before starting one
of the complete washing programmes. This
will prevent any grains of salt or salty water,
which may have been spilt, remaining on the
bottom of the machine for any period of time,
which may cause corrosion.
To fill:
1. Open the door, remove the lower basket
and unscrew the cap of the salt container
by turning it anticlockwise.
2. Pour 1 litre of water inside the container
(this is necessary only before filling
with salt for the first time) .
3. Using the funnel provided, pour in the salt
until the container is full.
2. Release the start/cancel button, the On/
Off and start/cancel indicator lights start
to flash indicating that you have activated
the water softener setting function.
3. At the same time, the end of programme
indicator light starts to flash.
The current level is indicated by the num-
ber of flashes of the indicator light end of
programme and a pause of about 3 sec-
onds.
Examples:
5 flashes, pause, 5 flashes, pause, etc...
= level 5
6 flashes, pause, 6 flashes, pause, etc...
= level 6
4. To change the level, press the start/can-
cel button. Each time the button is press-
ed the level changes.
Examples:
if the current level is 5, by pressing start/
cancel button once, level 6 is selected.
if the current level is 10, by pressing
start/cancel button once, level 1 is se-
lected.
5. To memorize the operation, switch off the
dishwasher by returning the programme
knob to the Off position.
4. Replace the cap making sure that there
is no trace of salt on the screw thread or
on the gasket.
5. Replace the cap tightly turning it clock-
wise until it stops with a click.
Do not worry if water overflows from the
unit when filling with salt, this is quite
normal.