Setting The Clock; Setting The Timer; Activating And Deactivating Sleep - Philips MCM108D/98 User Manual

Clock/Timer
M I C R O S Y S T E M
iR

Setting the clock

1
In Standby mode, press PROG/CLOCK
button.
➜
The clock digits for the hours flash.
2
Press ¡1 / 2™ to set the hours.
3
Press PROG/CLOCK again.
➜
The clock digits for the minutes flash.
4
Press ¡1 / 2™ to set the minutes.
5
Press PROG/CLOCK to confirm the time.
Note:
– If the clock has not been set, -- --:-- -- will be
displayed.

Setting the timer

●
The system can be used as an alarm clock. CD
or TUNER can be set to switch on at a preset
time. The clock time needs to be set first before
the timer can be used.
●
If no button is pressed within 90 seconds during
timer setup, the system will exit timer setting
mode automatically.
1
In any mode, press TIMER on the remote
control for more than 2 seconds.
2
Press ¡1 / 2™ (or CD/TUNER/DOCK on
the remote control) to select sound source.
3
Press TIMER to confirm your desired source.
➜
The clock digits for the hours flash.
M C M 1 0 8 D
4
Press ¡1 / 2™ to set the hours.
5
Press TIMER again.
➜
The clock digits for the minutes flash.
6
Press ¡1 / 2™ to set the minutes.
7
Press TIMER to confirm the time.
➜
The timer is now set and actiated.
Notes:
- If source CD is selected and no disc is in the CD
tray or the disc has an error, TUNER will be
selected automatically.
- If source DOCK is selected and no iPod/Philips
GoGear is docked or no dock connection is made,
TUNER will be selected automatically.
- At the set time of wake up, the set will turn on at
volume level 12, then the volume will slowly
increase to level 18.
To activate and deactivate timer
●
In standby or during playback, press
TIMER once.
➜
Display shows
if deactivated.
Activating and deactivating
SLEEP
The sleep timer enables the system to switch off
by itself after a set period of time. The clock time
needs to be set first before the sleep timer can
be used.
●
Press SLEEP on the remote
control repeatly to select
desired time before system
shuts off.
➜
Display shows
SLEEP
options for selection:
●
To deactivate, press SLEEP on the remote
control once or more until "
press STANDBY ON on the system or
remote control.
if activated, and disappears
SLEEP TIMER
and series of time
, , , , ,
" is shown, or
...
10