English Controls on the system and remote control BAND – for Tuner (on the set only) selects waveband. SOURCE (CD/ TUNER/ AUX) – switches on the system. – selects the respective sound source for CD/ FM/ MW/ AUX. STANDBY-ON / y –...
General Information Supplied accessories – 2 speaker boxes – remote control with 1 x CR2032 battery – MW loop antenna Environmental Information All unnecessary packaging has been omitted. We have tried to make the packaging easy to separate into three materials: cardboard (box), polystyrene foam (buffer) and polyethylene (bags, protective foam sheet).
Preparations Speaker (right) Rear connections The type plate is located at the rear of the system. A A A A A Power – Before connecting the AC power cord to the wall outlet, ensure that all other connections have been made. WARNING! –...
Preparations Speakers Connection Front Speakers Connect the speaker wires to the SPEAKERS terminals, right speaker to "RIGHT" and left speaker to "LEFT", the wire (marked red) to "+" and the wire (marked black) to "-". ● Fully insert the stripped por tion of the speaker wire into the terminal as shown.
Basic Functions STANDBY-ON SOURCE BAND PROG/CLOCK IMPORTANT: Before you operate the system, complete the preparation procedures. Switching the system on ● Press STANDBY -ON (y on the remote control). ➜ The system will switch to the last selected source. ● Press SOURCE (CD, TUNER or AUX on the remote control).
CD/MP3 Operation M I C R O S Y S T E M M C M 1 0 8 PROG IMPORTANT: The lens of the CD player should never be touched. Loading a disc This CD player plays Audio Discs including CD- Recordables, CD-Rewritables and MP3 CD.
CD/MP3 Operation Press ¡1 2™ to select a desired track. ➜ The album number will change accordingly as you reach the first track of an album by pressing ¡1 or the last track of an album by pressing 2™ . Press 2;...
Cleaning the disc lens ● After prolonged use, dirt or dust may accumulate at the disc lens. To ensure good playback quality, clean the disc lens with Philips CD Lens Cleaner or any commercially available cleaner. Follow the instructions supplied with cleaner.
Clock/Timer M I C R O S Y S T E M Setting the clock In Standby mode, press PROG/CLOCK button. ➜ The clock digits for the hours flash. Press ¡1 / 2™ to set the hours. Press PROG/CLOCK again. ➜...
Troubleshooting WARNING Under no circumstances should you try to repair the system yourself, as this will invalidate the warranty. Do not open the system as there is a risk of electric shock. If a fault occurs, first check the points listed below before taking the system for repair. If you are unable to remedy a problem by following these hints, consult your dealer or service centre.
Specifications AMPLIFIER Output power ... 2 x 2W RMS Signal-to-noise ratio ... Frequency response ... 60 – 16000 Hz, ± 3 dB Impedance loudspeakers ... 8 Impedance headphones ... 32 CD PLAYER Frequency range ... 20 – 20000 Hz Signal-to-noise ratio ... 75 dBA TUNER FM wave range ...