English - IKEA IDASEN Manual

ENGLISH

The appliance is not to be used by persons (including
children) with reduced physical, sensory or mental capa-
bilities, or lack of experience and knowledge, unless they
have been given supervision or instruction.
Children being supervised not to play with the appliance.
Advice and instructions for IDÅSEN.
Sound level:
Lower than 55 dB(A).
Height setting interval:
60-124 cm/23.6-48.8 inch
Maximum load:
75kg/165lbs.
Temperature interval at usage:
+50 up to +104 °F/+10 °C up to + 40 °C.
Temperature interval at storage:
0 up to 158°F/-18°C up to 70°C.
Humidity:
20% up to 90% at 104°F/40°C.
Power supply unit:
DC 24-29 V, 140-175 W.
Model:
ASW0539-24020002A
ASW0551-24020002A
ASW0552-29020002B
This appliance shall only be used
together with the included power
supply unit.
Every person who is responsible for this
table at installation or employment of
the table in daily use or in service and
repair work should carefully read these
instructions. Keep these instructions close
to your sit/stand table.
Installation instructions
— The table is assembled according to
separate assembly instructions.
— Connect the cable from one leg to the
other. Connect the hand control and
the power supply to the leg. The cables
to legs, hand control and power supply
should be placed in the tray created by
the frame. Place the electrical cables
so that they do not get damaged, see
assembly instruction.
— Connect the electrical cable to a wall
socket.
NOTE! The electrical cable must have
full mobility.
— The table is now ready for use. The
motors stop automatically when the
table reaches its lowest and highest
position respectively.
Usage of the table
— The table shall only be used as a
working table with the possibility to
continuously adjust working height
between sitting and standing position.
The table shall only be used indoors and
in dry premises (office environment or
similar).
The table must not be overloaded -
maximum load is 75 kg/165 lbs. The
system may be run continuously for
maximum 2 minutes. Afterward, the
motors must stand by for approx. 18
minutes before they can be used again.
4